Configuration Procedure - Siemens DMS8000 MP4 Series Installation, Configuration And Operations Manual

Configuring CCTV network
3.4.2

Configuration procedure

Building Technologies
Fire Safety & Security Products
The following are the configuration procedures for a MultiScope unit:
Adding the required Composer Plug-ins
1. Start the Subsystem Plug-in Installer,
in the Windows Start menu, launch the program:
Start  Programs  DMS8000  Tools  Subsystem Plug-in Installer
The Installer tool starts up and shows a dual-pane window.
2. In the right pane, select "Browser" and locate the Plug-in folder (see Fig 5).
This is a subfolder of the DMS8000 software, normally installed in "C:\Program
files". However, depending on your national version of Windows and on the op-
tions selected during the software installation, this folder may have a different
location on your hard disks.
Note that in the DMS800 folder there are multiple subfolders containing Com-
poser Plug-ins; e.g.:
- ST Plug-ins, which contains tools for MP3.20
- ST Plug-ins MP4.xx (e.g. MP4.10), which contains tools for MP4.xx
Fig 5 Installing the Composer Plug-ins
3. Click OK and open the Plug-in folder.
At this point, the pane on the right hand side shows the available packages.
4. Select the following packages:
- ST VD SIVMS – ST VD OPC (252101)
- ST OPCDRVST – OPC DRV ST (353801)
and click "Install" for each of them.
5. Check the resulting message at the bottom of the Installer window.
048_DMS_MM8000_GEUTEBRUECK_Add-On_MP4.20_A6V10067796_a_en
9
06.2009