Ordering Accessories; Warranty And Support - Philips S100 Series Manual

optimal shaving performance is
restored.
5 Remove the guard from the
cutter (Fig. 17).
6 Clean the cutter and guard
under the tap (Fig. 18Fig. 19).
- For additional cleaning you can
also start by using the cleaning
brush to remove hairs.
7 Put the cutter back into the
guard after cleaning (Fig. 20).
8 Put the shaving heads back into
the shaving unit (Fig. 21).
9 Put the retaining frame back into
the shaving unit and turn the
orange wheel clockwise (Fig. 22).
10 Put the shaving unit back onto
the shaver (Fig. 14).
Storage
We advise you to let the appliance
dry before you put the protection
cap on it.
1 Switch off the appliance.
2 Put the protection cap on the
shaving unit after use to prevent
damage and to avoid dirt
accumulation in the shaving
heads.
Replacement
For maximum shaving performance,
we advise you to replace the
shaving heads every two years.
Replace damaged shaving heads
immediately. Always replace the
shaving heads with original Philips
shaving heads (see 'Ordering
accessories').
For instructions on how to remove
the shaving heads, see chapter
'Cleaning and maintenance', section
'Every two months: shaving heads'.

Ordering accessories

To buy accessories or spare parts,
visit www.philips.com/parts-and-
accessories or go to your Philips
dealer. You can also contact the
Philips Consumer Care Center in
your country (see the international
warranty leaflet for contact details).
The following accessories and
spare parts are available:
- A00390 supply unit
- SH30 Philips shaving heads
- HQ110 Philips shaving head
cleaning spray
Recycling
- This symbol means that this
product shall not be disposed of
with normal household waste
(2012/19/EU).
- This symbol means that this
product contains a built-in
rechargeable battery which shall
not be disposed of with normal
household waste (2006/66/EC).
Please take your product to an
official collection point or a
Philips service center to have a
professional remove the
rechargeable battery.
- Follow your country's rules for
the separate collection of
electrical and electronic
products and rechargeable
batteries. Correct disposal helps
prevent negative consequences
for the environment and human
health.
Removing the rechargeable
battery
Only remove the rechargeable
battery when you discard the
shaver. Before you remove the
battery, make sure that the
shaver is disconnected from the
wall socket and that the battery
is completely empty
Take any necessary safety
precautions when you handle
tools to open the shaver and
when you dispose of the
rechargeable battery.
1 Check if there are screws in the
back of the shaver or in the hair
chamber. If so, remove them.
2 Remove the outer panels of the
shaver with a screwdriver or
other tool. If necessary, also
remove additional screws
and/or parts until you see the
printed circuit board with the
rechargeable battery.
3 Remove the rechargeable
battery.

Warranty and support

If you need information or support,
please visit
www.philips.com/support or read
the international warranty leaflet.