Philips S100 Series Manual page 4

- Never use
compressed air,
scouring pads,
abrasive cleaning
agents or aggressive
liquids such as
petrol or acetone to
clean the appliance.
- If your shaver
comes with a
cleaning system,
always use the
original Philips
cleaning fluid
(cartridge or bottle,
depending on the
type of cleaning
system).
- Always place the
cleaning system on
a stable, level and
horizontal surface
to prevent leakage.
- If your cleaning
system uses a
cleaning cartridge,
always make sure
the cartridge
compartment is
closed before you
use the cleaning
system to clean or
charge the shaver.
- When the cleaning
system is ready for
use, do not move it
to prevent leakage
of cleaning fluid.
- Water may drip
from the socket at
the bottom of the
shaver when you
rinse it. This is
normal and not
dangerous because
all electronics are
enclosed in a sealed
power unit inside
the shaver.
- Do not use the
supply unit in or
near wall sockets
that contain an
electric air freshener
to prevent
irreparable damage
to the supply unit.
Electromagnetic fields (EMF)
This Philips appliance complies
with all applicable standards and
regulations regarding exposure to
electromagnetic fields.
General
- This shaver can be safely
cleaned under the tap (Fig. 3).
- The supply unit is suitable for
mains voltages ranging from 100
to 240 volts.
- The supply unit transforms
100-240 volts to a safe low
voltage of less than 24 volts.
Charging
Charging takes approx. 10 hours. A
fully charged shaver has a shaving
time of up to 20 minutes.
- Charge the appliance when the
motor stops or starts running
slower. For optimal
performance, only charge the
shaver when the battery is low.
- Make sure the shaver is
switched off when you start to
charge it.