Dismantling - Husqvarna 555FX Workshop Manual

Electrical system

Dismantling

Dismantle the starter, air guide plate,
cylinder cover, muffl er guard and the
spark plug.
Attach piston stop no. 502 54 15-01.
Remove the nut holding the fl ywheel.
Remove the fl ywheel.
Dismantle the alternator if necessary.
Dismantle the ignition module.
A
B
C
B
502 54 15-01
502 51 49-01
502 51 94-01
502 50 18-01
Dismantling
Dismantle the starter, air guide plate,
cylinder cover, muffl er guard and the
spark plug.
Fit piston stop no. 502 54 15-01 in the
spark plug hole.
NOTE!
Place the piston stop so it is
caught between the piston and
the cylinder head. Not so it sticks
out into the exhaust port.
Remove the nut holding the fl ywheel.
Remove the fl ywheel from the
crankshaft using punch no. 502 51 94-
01.
Leave a gap of approx. 2 mm between
the punch and the fl ywheel.
Gently knock the punch with a hammer
while holding the fl ywheel with your
other hand.
Heat the fl ywheel using a hot air gun
if necessary or use puller no 502 51
49-01.
Remove the alternator that supplies
power to the heated handles.
Dismantle the ignition module.
Remove the ignition cable from cable
channel (A).
Remove both bolts (B).
Loosen the short-circuit cable (C) from
the ignition module.
2
11