E
E
E
F
G
Electrical system
Dismantle the short-circuit cable from the
ignition module.
Dismantle the ignition module and the
centrifugal clutch.
502 50 18-01
Remove the nut holding the fl ywheel.
502 51 49-01
Dismantle the guard plate under the en-
gine body (2 remaining screws).
Lift out the ignition lead and short-circuit
cables from their guides.
Remove the 3 screws (E) and swing the
engine body to one side so the clutch
becomes accessible.
Dismantle the short-circuit cable from the
ignition module by removing the screw (F)
and prying off the fl at pin connector (G).
Remove the remaining screws (A) holding
the ignition module and both screws (B)
that hold the centrifugal clutch.
Lift off the clutch, both support washers
and the ignition module.
Remove the nut holding the fl ywheel.
Fit the puller on the fl ywheel. Loosen and
remove the nut.
2
11