Husqvarna 322HD60 Workshop Manual page 34

10. Remove the heat shield.
11. Remove the 2 screws, the cylinder, and the cylinder
gasket.
34 - Repair instructions
12. Put a cloth above the crankcase opening below the
piston.
13. Remove the snap rings on the piston pin with a
small flat nose pliers. Hold your finger on the snap
ring to make sure it does not eject.
14. If the piston pin is too tight, carefully increase the
temperature with a hot air gun. Refer to
tools on page 10 .
CAUTION: Make sure that you keep the 2
distance rings that are between the piston
and the piston pin bearing.
Servicing
1369 - 001 - 13.02.2020