Husqvarna 123HD60 Workshop Manual page 7

Starter
Assembly
Fit the return spring in the starter housing.
The pressure equalisation spring is sup-
plied as a spare part, fi tted to the starter
pulley.
Attach the new starter cord.
Lubricate the return spring and position
the starter pulley.
Assemble the drive disc.
Assembly
If the return spring has, despite all the
precautions, fl own out or if you intend to fi t
a new spring proceed as follows:
1. The lies tensioned with a sturdy steel
wire in shrink wrap.
Cut the package open very carefully in
order to prevent the spring from pop-
ping out.
2. Position the spring in the starter hou-
sing.
3. Keep the spring in place using one of
your thumbs at the attachment in the
starter pulley.
4. Use a screwdriver to fi rst push the
spring down by its attachment in the
starter pulley and then on the diametri-
cally opposite side so that the steel
wire (A) slides off the spring.
The pressure equalisation spring is sup-
plied as a spare part, fi tted to the starter
pulley.
Attach the new starter cord.
Make sure the knot is as small as possible
and fi ts into the notch in the pulley.
Pulley diameter: Ø 2 mm.
Lubricate the return spring and the star-
ter pulley's stub axle with cold resistant
grease or thin oil.
Move the starter cord through the guide
in the starter housing (A).
Guide the free end of the return spring
in towards the spring attachment on the
hub of the starter pulley (B) and slide
the starter pulley down into the starter
housing.
Put the drive disc (A) in place above the
starter pulley and make sure that it grips
the pressure equalisation spring (B) in
the correct way.
Tighten the screw with the underlying
washer (C).
1
5