Wiring Diagram, Cabling - 230 V - Husqvarna K 3000-Electric Workshop Manual

6
BLACK
BLACK
WHITE
BLACK
Earth fault breaker
1
3
f
8
WIRING DIAGRAM, CABLING – 230 V
GREY
GREY
GREY
GREEN/YELLOW
BROWN BLACK
BLUE
WHITE
GREEN/YELLOW
2
4
g
Stator
Rotor
GREY
Stator
e
a
d
c
b
Assembly diagram
The assembly diagram shows the colours
and positions of the connection cables
for the electrical connections.
Components/cables
Illustration 1. Removal
Remove the cover to the carbon brushes,
see "carbon brushes" chapter, page 6.
Remove the screws as shown in the
illustration.
The illustration below shows the position
of the components and cables in the
handle.
Illustration 2
a. The flat pin contacts connect to the
stator windings.
b. Earth connector from mains cable.
c. Screw for earth connection.
d. Earth connector from earth point to
circuit board.
e. Outgoing from switch.
Illustration 3
f. Incoming earthed mains cable.
g. Incoming cables to switch.
Illustration 4
The illustration shows the attachment of
the circuit breaker cables (black and
white).
The dashed line shows the routing for
the cables between the circuit board and
the switch (e). Note that the cables must
be behind the circuit board guide slot.