Husqvarna K 3000-Electric Workshop Manual page 29

CUTTING UNIT – Cut-n-Break
Removal
Add a wooden block under the
cutting arm. Place the ball bea-
ring on the bearing holder and
knock so that a gap appears bet-
ween the bearing holder and
cutting arm.
Turn the cutting arm and break
up the bearing holder.
Fit the bearing holder
The bearing is best fitted by
pressing.
Alternatively the bearing hol-
der can be knocked into place
with a small plastic hammer.
Removal
Add a wooden block under the cutting
arm right next to the bearing holder.
Place the ball bearing on the bearing
holder and knock the outer ring so that a
gap appears between the bearing holder
and cutting arm.
Turn the cutting arm and break up the
bearing holder gradually with a screw -
driver all around.
Fit the bearing holder
The bearing is best fitted by pressing.
Alternatively the bearing holder can be
knocked into place with a small plastic
hammer. Knock a few light strokes
around the ring so that it drops down
parallel to the cutting arm.
18
29