Husqvarna K 3000-Electric Workshop Manual page 27

CUTTING UNIT – Cut-n-Break
Belt replacement
Fold aside the splash guard
Force off the rubber guard from
the screw.
Fold down the splash guard.
Remove belt guards
Remove the screws and nuts as
shown in the illustration.
Remove the belt wheel
Lock the dog and remove the
centre screw.
Reassembly
Attach the cutting arm to the gear housing provisionally with both nuts.
Fit the belt
Apply the belt to the belt guard.
Fit the front belt guard
Fit the front belt guard. Fit the four screws. Place the spring catches on both
sides of the belt guard and fit the fifth screw.
Fit the belt wheel
Fit the rear belt guard
Remove the provisionally mounted nuts and fit the rear belt guard. Fit the
nuts and tighten by hand. Fit the screw and adjustment washer for belt
tensioning.
Fit the blade, tension the belt
See page 26.
Belt replacement
Fold aside the splash guard
Force off the rubber guard from the screw.
Push the splash guard into smooth cut -
ting position and fold down the splash
guard.
Remove belt guards
When the screws and nuts have been
removed as shown in the picture, the
cover plates can be removed.
Remove the belt wheel
Lock the dog and remove the centre
screw. Lift off the belt wheel.
When refitting note that the belt wheel
is not symmetrical.
18
27