Assembling The Steering Shaft; Dismantling/Assembling The Cable Pulley - Husqvarna M105-85F Workshop Manual

Hide thumbs

Table Of Contents

Table of Contents

Assembling

Attach the cable by first turning the steering wheel so that the

hole in the steering column guide roller points forward on the

machine.

Place the center nipple of the cable in the hole with the

marked part of the cable to the right in the direction of travel.

Wind the right end of the cable one turn clockwise under the

nipple and turn the left end counterclockwise above the

nipple so that both ends point towards the rear.

The cable is correctly fitted if it exits at the top on the left side and

the bottom on the right side.

At this stage, the cable can be fixed in position with a cable tie

or tape, for example.

Pull back the ends of the cable and place in the correct

tensioner. Do not forget to screw a nut (M8) onto each

tensioner that is used to secure the cable.

13 – English

REPAIR INSTRUCTIONS

The marked (right) side of the cable is placed at the bottom of

both pulley brackets and connected to the rear steering disc

on the right side of the machine.

Note that the wire must be placed in the groove in the plastic

sprocket before it is all run back to the top of the shaft. If the

machine has hydrostatic transmission (M125-97FH), the right

cable must be routed under the parking brake arm on the

hydrostatic box and the left cable must be routed over the

parking brake arm.

Place the washers between the pulleys and lay the left end of

the wire at the top and connect it to the left attachment of the

steering disc.

Stretch the ends of both cables equally so that the steering

wheel position does not change. Hold the cable with pliers or

a wrench so that it does not twist. Secure the wire with the

inner nuts (M8).