How To Use The Timer - DeLonghi TRD04 Series Instructions For Use Manual

Caution
Always operate the heater in upright position only (wheels
on the bottom, controls on top).
Any other position could create a hazardous situation.
Location
The heater should not be placed immediately below a power
outlet. Do not use this radiator in rooms with a floor area of
less than 4 m 2 (43 sq. ft. ).
Connection
- Before using the appliance check that your supply volta-
ge is the same of that shown on the rating label of the
unit and that the power socket and power supply line
correspond to the load specified.
- Check also the current capacity of your fuses. CONNECT
YOUR HEATER TO EARTH PROVIDED SOCKET ONLY.
Turning on
Insert the plug into an electrical outlet, rotate the thermostat
knob (A) to maximum and turn the unit on as follows using
the power selector:
- Turn the power selector dial (B) to the
retain the time set only.
- Turn the power selector to position MIN to select
minimum output (the min light will be on).
- Turn the power selector to position MED to select
medium output (the min/med light will be on).
- Turn the power selector to position MAX to select
maximum output (the lights will be on).
Adjusting the thermostat
When the room has reached the desired temperature, turn
the thermostat knob slowly in an anti-clockwise direction
until you hear a "click" and not beyond it. The thermostat
will then adjust the set temperature automatically and
keep it constant. If your unit is a three power version, in
intermediate seasons or on days when temperatures are not
particularly cold, select minimum output to optimize savings
and consumption.
Antifreeze function
Turn the thermostat dial to the
selector to position MAX. The appliance will maintain a
minimum room temperature of approximately 5°C, thus
preventing freezing while conserving energy. In models that
come with a timer, teeth must be set in the inward position.
position to
position and the power
Reminder
To completely shut the appliance off, turn the power selector to
the "0" position and then unplug the appliance from the outlet.

HOW TO USE THE TIMER

To program heating, proceed as follows:
- Look at the time on your clock or watch. If it is 10
p.m., turn the numbered timer disk clockwise until
the number 22 (10 p.m.) on the disk coincides with
the pointer s on the timer. Set the periods of time
when you want the appliance to work by pushing the
teeth inward. Each tooth corresponds to a period of 15
minutes. This will leave visible sectors which correspond
to the periods of operation. When set, the radiator
will operate automatically each day during the times
programmed (important: the radiator must always be
plugged into the socket).
- To change the programming, move the teeth and set the
new periods of operation.
- To turn the appliance off, turn the power selector to "0".
In this position, the time will not be retained. If on the
other hand you want to retain the time set, turn the
power selector (B) to the
Important! DO NOT ROTATE CLOCK DIAL COUNTER-
CLOCKWISE.
The timer is like an electric clock, and will only work when
plugged into a power supply.
Timer override
If you wish to override the timer settings, push the timer
switch to position I (fig.2) manual (timer override). To return
to timed operation push the switch back to the middle
position (fig.2).
NOTE: if the timer switch is at the 0 position (fig. 2),
the heater is off and will not operate).
5
position.
Fig. 2
Heater off
Timer operation
Manual (timer override)