Table of Contents
Advertisement
Before Using Your
Refrigerator
It is important to prepare your refrigerator for use. This section tells you how to clean it,
connect it to a power source, install it and level it.
Cleaning
your refrigerator
Removing
packaging
materials
NOTE:
Do not remove any permanent
Remove tape and any inside labels (except
instruction labels inside your refrigerator.
Do
the model and serial number label) before
not remove the Tech Sheet fastened under
using the refrigerator.
the refrigerator at the front.
To remove any remaining glue:
Cleaning
it before
use
l
Rub briskly with thumb to make a ball,
then remove.
OR
l
Soak area with liquid hand dishwashing
detergent before removing glue as
described above. Do not use sharp
After removing all packag-
ing materials, clean your
refrigerator before using it,
if necessary. See cleaning
instructions
on pages 14-l 5.
instruments,
rubbing alcohol, flammable
fluids or abrasive cleaners. These can
damage the material. See 'Important
Safety Instructions"
on page 3.
Plugging
it in
Recommended Grounding Method
A 115 Volt, 60 Hz., AC only 15 or 20 ampere
fused and properly grounded electrical
supply is required. It is recommended
that a
separate circuit serving only this appliance
be provided. Use a receptacle which cannot
be turned off with a switch or pull chain. Do
not use an extension cord.
See Electrical Requirements
and Ground-
ing Instructions
Sheet in your Literature
Package.
WITH
QUESTIONS
OR COMMENTS
Advertisement
Table of Contents
