Towing Log Splitter Safety; Log Splitter Location - Champion 100883 Operator's Manual

100883 - 27 TON LOg SPLiTTER
3. Pull out the spring loaded "Quick-Lock" pin and rotate it
around to the 9 o'clock position around the lip on the beam to
secure it in the vertical position.
4. To change from vertical to horizontal orientation, reverse the
steps. The beam will automatically lock into the "Auto-Lock"
on the tow bar when lowered into position.

Towing Log Splitter Safety

1. Always check local, state or provincial regulations regarding
towing, licensing and lights before towing your log splitter.
Review towing safety warnings in your towing vehicle manual.
2. Before towing make sure the log splitter is correctly and
securely attached to the vehicle and the safety chains
attached with enough slack to allow for turning.
3. Support leg must be pinned in the "UP" position for towing.
4. Never exceed the max. travel speed of 45 mph (72 km/h).
Towing the log splitter at speeds greater than 45 mph
(72 km/h) could result in serious injury or death. Always
adjust your towing speed according to the terrain and
conditions.
5. Always disconnect the log splitter from the towing vehicle
before operating.

Log Splitter Location

This log splitter must have at least seven feet of clearance from
combustible material. Leave at least three feet of clearance on all
sides of the log splitter to allow for adequate cooling, maintenance
and servicing. DO NOT place the log splitter near vents or intakes
where engine exhaust fumes could be drawn into occupied or
confined spaces. ONLY operate the log splitter outdoors.
The log splitter needs to be on a dry level surface with good
footing. DO NOT work on mud, ice, tall grass, brush or snow.
Only operate log splitter from work zone shown below.
22
OPERATiON
hORIZONTaL
OPERaTING POSITION