Cable Diagram - Hitachi S10 Series Manual

5

Cable Diagram

The cable diagram shown below may be different from the cable diagram recommended by Hitachi, Ltd..
Please be assured there is no operational problem in applying the cable diagram shown in this manual.
• The FG pin of the main body of the External Device must be D-class grounded. Please refer to the manual of
the External Device for more details.
• SG and FG are connected inside the Display. When connecting SG to the External Device, design the system
not to form short-circuit loop.
• If the communication is not stable due to the noise or other factors, connect the isolation unit.
Cable Diagram 1
Display
(Connection Port)
*1
GP3000 (COM1)
AGP-3302B (COM2)
GP-4*01TM (COM1)
GP-Rear Module
(COM1)
*2
ST (COM2)
LT3000 (COM1)
*3
IPC
*4
GP3000 (COM2)
GP-4116T (COM1)
*5
GP4000 (COM2)
GP-4201T (COM1)
*6
SP5000 (COM1/2)
SP-5B00 (COM2)
*8
PE-4000B
*8
PS5000
*1 All GP models except AGP-3302B
*2 All ST models except AST-3211A and AST-3302B
*3 Available to use only the COM ports which can communicate in RS422/485(4 wire). (Except PE-4000B,
PS5000)
" IPC COM Port" (page 4)
GP-Pro EX Device/PLC Connection Manual
COM port conversion adapter by Pro-face
1A Connector terminal block conversion adapter by Pro-face
1B
Online adapter by Pro-face
1C Connector terminal block conversion adapter by Pro-face
Online adapter by Pro-face
1D
1G
RS-422 Terminal Block Conversion Adapter by Pro-face
1E
1B
1F
Cable
CA3-ADPCOM-01
+
CA3-ADPTRM-01
+
Your own cable
Your own cable
CA4-ADPONL-01
+
CA3-ADPTRM-01
+
Your own cable
CA4-ADPONL-01
+
Your own cable
Your own cable
*7
PFXZCBADTM1
+
Your own cable
Your own cable
Your own cable
23
S10 Series SIO Driver
Remarks
Cable length:
500m or less
Cable length:
500m or less
Cable length:
500m or less
Cable length:
500m or less
Cable length:
500m or less