4 FL.NET MODULE WIRING PROCEDURES
4.1 Connecting the Communication Cable
The module uses the 100BASE-TX interface connector to establish communication with the other
modules.
Ensure that the cable is connected as shown in Figure 4-1.
LQE702
FL.NET
RUN
LER
ERR
COM
100MLINK
MAIN
/SUB
100BASE-TX
Figure 4-1 100BASE-TX Communication Cable Wiring
This hardware unit may malfunction if it is connected poorly or has a broken
line. After connecting the connector, check whether the locking.
Do not touch the connector during power on. Otherwise, the system may
malfunction due to static electricity, etc.
Insert the communication cable into
the RJ45 connector.
100BASE-TX communication cable
Use a straight cable when you want to connect a hub or
router to the FL.NET module.
NOTICE
4-2