Whirlpool 8500 Series Use And Care Manual page 7

Adding a dish during a cycle
You can add an additional item to the dishwasher anytime before the Cycle Control knob
reaches LIGHT WASH. See page 8.
1. Lift up on the door latch to unlatch the
30 seconds for air in the dishwasher to
door and stop the cyde. Wait a moment
warm up. This helps reduce the amount
for the spray action to stop before open-
of moisture that can come from the vent
ing the door. when restarting the cyde.
2. Open the door and add the dish.
4. Press door in to latch it. The dishwasher
3. Close
the door.
Do not latch it. Wait
will start where it stopped.
Changing a cycle setting
You can change a setting anytime during any cycle.
1.
2.
3.
4.
Lii up on the door latch to unlatch the
door and stop the cycle.
Turn the Cycle Control knob dockwise to
the cycle you want.
Push the desired Cycle Selection button.
Check the detergent dispenser to be sure
it is properly filled for the new cycle. See
page 10.
NOTE: Turning the Cycle Control knob
may cause the covered section of the
detergent dispenser to open. Be sure to
fill the covered section if the cycle uses
detergent in both sections.
Close and latch the door. The dishwasher
will automatically start the new cycle.
Changing an option
You can change an option anytime during a
cycle. To change the selected option(s):
1. Push the RESET OPTIONS button.
2. Push an Option Selector button for each
desired option.
Canceling a cycle
You can cancel a cycle anytime during the cycle.
1. Turn the Cycle Control knob slowly
2. Let the dishwasher drain completely.
clockwise to the drain portion of the wash
or rinse. You will hear water draining
3. Lii up on the door latch to unlatch the
door.
when you have advanced to the proper
location.
4. Turn the Cycle Control knob clockwise to
point to OFF.