Whirlpool 8500 Series Use And Care Manual page 20

When cycle is finished
1. Turn hot water off. (This can be done after the
last rinse.)
Locking collar
/
2. Press the red button on the connector to
release the water pressure.
3. Lit slightly on the hose connector while pulling
down the locking collar. Pull down on the
connector.
4. Empty any remaining water from the connector
by turning the connector upsidedown.
5. Unplug power supply cord and return to
storage compartment.
6. Return hoses to storage compartment.
\
Hose connection
Electrical connection
A power supply of 120 volts, 60Hz AC, 15 or 20
amps, is required. For your personal safety, this
appliance must be grounded. This appliance is
equipped with a power supply cord having a
3-prong grounding plug. To minimize possible
shock hazard it must be plugged into a mating 3-
prong grounding type wall receptacle, grounded
in accordance with the National Electrical Code
and local codes and ordinances. If a mating wall
receptacle is not available, it is the responsibility
and obligation of the customer to have a properly
grounded 3-prong wall receptacle installed by a
qualified electrician.
Personal Injury Hazard
An extension cord should not be used
with this appliance.
Such use may result in a fire, electrical
shock or other personal injury.
&prong
grounding
Power supply
C&prong
grounding type
wall receptacle
Do not, under any circumstances,
remove the power supply cord ground
prong.
Converting to built-in
Your Whirlpool Portable Dishwasher can be
converted to a built-in (undercounter) model by
using conversion kit No. 4317856. The kit is
available at your Whirlpool dealer or authorized
Whirtpoot@ service company. tnstructions are
included with the kit.
20