Table of Contents
Advertisement
4. Behavior of the detector
For detailed information, please refer to the installation manual of the
presence detector.
4.1 Reception of a value/command
The reception of a valid value or command is indicated by a flickering
(2 sec.) of the LED on the detector.
4.2 Reception of new setting values
● The contact „Light" reacts immediately on brightness (to check the
brightness threshold).
● If the brightness is insufficient the light is switched on (LED on), if the
brightness is sufficient the light is switched off (LED off).
● The light is switched fully automatically (no semi-automatic operation).
4.3 Local setting of the potentiometers
When changing a single potentiometer value on the
presence detector, all existing potentiometer settings
will be taken over. All programmed values will be lost.
4.4 Power failure
The current settings are retained no matter whether they have been set
using the remote control or locally on the device.
GB
43
Advertisement
Table of Contents
