Maintenance; Spare Parts List - WAGNER W 350 Operating Instructions Manual

AUS
2) Put the nozzle (fig. 9 B, 3) onto the gun body and find the correct position by turning it.
3) Put the air cap onto the nozzle and tighten it using the union nut.
4) Place the container seal from below on the suction tube and slide it over the collar,
while turning the container seal slightly.
5) Insert the suction tube with container seal in the gun body.

13. Maintenance

Air filter
WARNING! Never operate the machine without the air filter; dirt could be
sucked in and interfere with the function of the machine. Disconnect plug
before changing parts.
•
Press both locks and remove the filter cover (Fig. 8).
•
Remove the air filter and replace depending on contamination.
•
Click the filter cover in place again.
•
In order to mount the gun more easily apply lubricating grease (enclosed) liberally
to the O-ring at the gun front part. (Fig. 9, Item 5)
Ventilating hose / Valve
1) Pull the ventilating hose (Fig. 9 A, 13) at the top from the gun body. Screw off the valve
cover (14). Remove the diaphragm (15). Carefully clean all parts or replace in the
event of damage.
2) Place the diaphragm (Fig. 9 A, 15) with the pin facing upwards on the bottom section
of the valve. Also see the marking on the gun body.
3) Place on the valve cover (Fig. 9 A, 14) and screw it closed.
4) Place the ventilating hose (Fig. 9 A, 13) on the valve cover and on the nipple at the
gun body.

14. Spare Parts List

Pos. Designation
1 Union nut
2 Air cap
3 Nozzle
4 Nozzle seal
5 O-ring
6 Material volume regulation with spring, complete
7 Spray gun front part complete incl. 800 ml container
8 Air filter
9 Air filter cover
8
Spare Parts List (Fig. 9)
W 350
Order No.
2362 873
2361 747
2362 878
0417 706
2362 875
0417 910
2361 731
2370 530
2370 532