Advertisement
HMI (Human-Machine Interface)
Push-button operation
Activity
Enter / leave addressing mode
Reset to factory settings
PL-Link connection test
LED colors and patterns
Color
Off
Green
Orange
Red
4)
Function or part of the function available in PL-Link operation only
Addressing and bus test with push button
The damper actuators can be set into addressing/programming mode by push-button:
▪
Press push button (>0.1 s and <1 s)
▪
KNX bus wiring OK → LED turns red until addressing/programming is finished
▪
KNX bus wiring not OK → LED stays dark
Reset with push button
The damper actuators can be reset to the OEM default values by push-button:
▪
Press push button > 20s
▪
LED flashes orange
▪
Device restarts
All parameters are set to factory settings.
4 / 10
Siemens
Smart Infrastructure
Push-button operation
Press button <1 s
Press button >20 s
4)
Press key >2 s and <20 s
Pattern
Description
---
Fault free operation or device not powered
steady
Connection test successful
flashing
a) Factory reset in progress
b) When a connection test was triggered: wait
steady
a) Device is in programming/addressing mode
b) When a connection test was triggered: Connection test failed
Confirmation
LED turns red or turns off
LED flashes orange until device restarts
LED flashes orange 1x
4)
4)
A6V11753386_en--_a
4)
2020-02-25
Advertisement
