Installation; Operation Check; Operating Procedure - LG MS2025DB Owner's Manual

Install your oven by the following three simple steps:
% a s
1. Remove all packing materials and accessories.
2. Place the oven in the level location of your choice but make sure there is at least 10 cm of space on
the top and at the rear for proper ventilation. The side of the oven should be kept clear so there is
airflow for ventilation.
An exhaust outlet is located on top or side of the oven. Blocking the outlet can damage the oven.
1. Plug your oven into a standard household outlet. Be sure the electrical circuit is at least 15 A or above
and that your microwave oven is the only appliance on the circuit.
Note
• If your oven does not operate properly, unplug it from the household outlet and then plug it
back in.
• This appliance should not be used for commercial catering purposes.
After unpacking this appliance, examine the new oven for evidence of shipping damage. This is most
important since a damaged oven may allow the escape of microwave energy. Make sure you remove
all packing from the microwave cavity. Refer the Owner's Manual for checking oven operation after
unpacking the unit or if oven is not working properly.
1. Plug the power cord into an earthed electrical socket.
2. Place the rotating ring & glass tray inside the oven cavity.
3. Place a cup of water (at room temperature) inside the oven, on the glass tray.
4. Close the door securely.
5. Turn the POWER SELECT KNOB to max.
6. Set the Timer for 3 to 4 minutes (note , the oven lamp turns ON and microwave activity starts)
7. When the cooking time has elapsed, the signal will sound (note, the oven lamp turns off and all
microwave activity stops.)
8. If the oven is operating normally the water will be hot.
This microwave oven is designed to be simple and
easy to operate. Please follow these instruction
carefully.
1. Place the food in a suitable cooking utensil. Open the microwave oven door and place the utensil in the
centre of the oven on the glass tray.
2. Close the oven door.
3. Select the desired power level depending on the food to be cooked.
For your information the setting provide the following power levels:
(All figures are quoted as an approximate percentage of the full available power).

Installation

Operation Check

Operating Procedure

MS2025DB
Max
500
350
Defrost
70
8