End Of Cycle Signal - Roper REX3615EW0 Use And Care Manual

WRINKLE PREVENT" Feature
(on some models)
When you are unable to remove a load from
I the dryer as soon as it
stops, wrinkles can form.
The WRINKLE PREVENT
feature tumbles the load
without heat every few
minutes up to 45 minutes
after the cycle ends. This
tumbling rearranges and
fluffs the load to avoid
wrinkles.
You do not have to set the Cycle Control
Knob for the WRINKLE PREVENT feature. If
you do not open the dryer door within a few
minutes after the cycle stops, the WRINKLE
PREVENT feature takes over to protect the
load.
A signal sounds every few minutes
when WRINKLE PREVENT is running. The
signal and cycle stop when you open the
dryer door.
End of cycle signal
(on some models)
The dryer sounds a signal to let you know
when the cycle is finished. The signal is
helpful when you are drying permanent
press, synthetics, and other items that
should be removed from the dryer as soon
as it stops. The End of Cycle On/Off Selec-
tor is part of the Start Button, as shown.
NOTE: Unless you turn the Selector to Off,
the end of cycle signal sounds at the end of
the drying cycle.