Advertisement
Procedure
NOTICE
Material damage caused by electrostatic charge.
ESD devices can be destroyed by voltages well below the threshold of human perception.
These static voltages develop when you touch a component or electrical connection of a
device without having discharged your own body. The electrostatic discharge current may
result in latent failure of a module, that is, this damage may not be apparent immediately,
but may cause malfunction after a lengthy period of operation.
Note
Locking switch
Make sure that the locking switch on the rear of the 3RW5 HMI Standard is in the required
position.
For more information in Chapter "Standard 3RW5 HMI (Page 18)".
● Observe the coding of the plug and socket
● Lock the connector in the socket
● Observe the cable routing:
①
③
● Replace the hinged cover of the 3RW51 soft starter as required (Page 51).
3RW51 Soft Starter
Manual, 06/2019, A5E37108631002A/RS-AB/002
Cable routing to the bottom
Cable routing to the left
3.5 Installing / mounting / removing 3RW5 HMI
①
③
+
.
②
.
Mounting and Dismantling
37
Advertisement
