Table of Contents
Advertisement
Details of Updated Projector Menus (Version 1.50)
• Do not copy any other files or folders to the removable disk.
Otherwise, the files or folders may be lost.
a
• The projector turns off automatically if the USB cable or the
power cord are disconnected before the firmware file can be
copied to the removable disk. Perform the procedure again.
f
Perform the steps to safely remove a USB device from the computer
and disconnect the USB cable from the projector.
All of the projector's indicators start flashing and the firmware update
starts. After the update finishes normally, the projector enters standby
mode (only the power indicator is lit blue). If Direct Power On is set to
On in the projector's Operation menu, the projector turns back on
again.
After finishing the update, check the Information menu from the projector's
Management menu to make sure Version is updated to the desired firmware
version.
• When all indicators flash rapidly, the firmware update may have
failed. Disconnect the power cord from the projector and then
reconnect it to the projector. If the indicators continue to flash even
a
after reconnecting the power cord, remove the power plug from the
electrical outlet and contact Epson.
• If no operations are performed for 20 minutes in update mode, the
projector turns off automatically. Perform the procedure again.
14
Advertisement
Table of Contents
