State Of Charge; Leds; Assembling The Trimmer; Mounting The Deflector - Stihl FSA 45 Instruction Manual

7 Assembling the Trimmer

► Insert the charger plug (3) in the charge socket (2).
The LEDs (1) glow green and show the state of charge.
► If the LEDs (1) stop glowing: Disconnect the charger plug
(3) from the charge socket (2).
The trimmer is fully charged.
► Disconnect the plug (5) from the wall outlet (6).
6.2

State of Charge

80-100%
60-80%
40-60%
20-40%
0-20%
► Press the button (1).
The LEDs (5) glow green for about 5 seconds and indicate
the state of charge.
► If the left LED flashes green: Recharge the trimmer.
6.3

LEDs

Indicate state of charge or malfunctions in the trimmer. The
LEDs can glow or flash green or red.
The state of charge is indicated when the LEDs glow or flash
green.
► If the LEDs glow or flash red: Troubleshooting, @ 18.
There is a malfunction in the trimmer.
7 Assembling the Trimmer
7.1

Mounting the Deflector

► Switch off the trimmer and remove the activation key.
0458-718-9821-B
1
1
2
The line limiting blade (1) is already installed in the deflector
(2) and must not be removed.
► Push the deflector (2) into the guides on the housing as far
as stop.
The deflector (2) is tight against the housing.
► Insert and tighten down the screws (3) firmly.
The deflector (2) must not be removed again.
7.2

PolyCut 2-2 Mowing Head

7.2.1 Fitting Mowing Lines
► Switch off the trimmer and remove the activation key.
► Place mowing lines in a container filled with water for 12
to 24 hours before using.
This makes the nylon mowing lines supple.
1
► Push mowing line up through the right opening from
below.
English
3
2
2
41