Pioneer DMH-WT8600NEX Operation Manual page 109

Menu Item
[3D Calibration Status]
[Connection Status]
[GPS Antenna]
[Positioning Status]
[Installation]
[Speed Pulse]
[Back Signal]
[License]
Description
Check the sensor learning status, such as the degree of
learning. You can also check the current sensor values and
the total number of speed pulses.
To delete the learned results stored in the sensor, follow
the below instructions.
1
Touch [Distance] or [Speed Pulse], and then touch
[Yes].
2
Touch [Learning status] and then touch [Reset All].
TIP
Touch [Reset All] to reset the sensor after changing the
installation position or angle.
NOTE
If you touch [Reset Distance], all learned results stored in
[Distance] are cleared.
Check that the leads are properly connected between this
product and vehicle.
Displays the connection status of the GPS antenna ([OK] or
[NOK]) and the reception sensitivity.
NOTE
If reception is poor, change the installation position of the GPS
antenna.
Displays the positioning status (3D positioning, 2D
positioning, or no positioning), the number of satellites
used for positioning (orange), and the number of satellites
that have received signals (yellow). If signals from more
than three satellites are received, the current location can
be measured.
Indicates whether the installation position of this product
is correct or not. If installed correctly, [OK] appears. When
this product is installed at an extreme angle exceeding the
limitation of the installing angle, [NOK(Inst. Angle)] is
displayed. If the installation of this product is continually
changed and it is not firmly fixed into place,
[NOK(Vibration)] is displayed.
The speed pulse value detected by this product is shown.
When the shift lever is shifted to "R" (reverse position), the
signal switches to [High] or [Low]. The signal displayed
varies depending on the vehicle.
Displays the open source license for this unit.
- 109 -