Mixing Ingredients - Waring WSM10L Manual

ATTACH AGITATOR TO MIXER
(i.e., Beater, Mixing Paddle, Dough Hook, Whisk)
Install bowl BEFORE attaching agitator.
NOTE: It is easier to install the agitator before adding the ingredients
into the bowl.
1. Rotate bowl guard to the left, so it
rests in the open position.
Using excessive force to open and close
bowl guard can damage the spring lock
and bowl guard microswitch, and
WILL VOID the warranty.
2. Slide the agitator slowly upward onto
the planetary shaft, fitting the shaft pin
through the slot in the agitator (Fig 3).
3. Rotate agitator clockwise to secure
it onto the planetary shaft.
CAUTION

MIXING INGREDIENTS

Overloading or not following the capacity chart will damage the mixer
and void the warranty. Refer to Capacity Chart section.
Before starting the mixer: Always change to the desired speed
BEFORE starting the mixer. Failure to do so can damage the gears or
other parts and WILL VOID the warranty.
Agitators must always rotate in a counterclockwise direction around
the bowl. If the agitator moves clockwise, contact a licensed
electrician immediately to remedy incorrect wiring.
IMPORTANT: It is recommend to always start with Speed 1
when starting the mixer. Failure to do so can damage the gears
or other parts.
1. Add the appropriate mixing ingredients to the bowl.
2. Rotate bowl-lift lever up, until the bowl locks into position.
3. Rotate bowl guard to the right, until it locks into the closed
position. You will hear it click into place.
NOTE: Mixer will not start if bowl guard is open or bowl is in the
lowered position.
10
FIG. 3