2.1
Setting the Jumpers
Set up and configure your board by using jumpers for various settings and features
according to your needs and applications. Contact your supplier if you have doubts
about the best configuration for your use.
2.2.1
How to Set Jumpers
Jumpers are short-length conductors consisting of several metal pins with a
non-conductive base mounted on the circuit board. Jumper caps are used to have
the functions and features enabled or disabled. If a jumper has 3 pins, you can
connect either PIN1 to PIN2 or PIN2 to PIN3 by shorting.
Pin#
1
A 3-pin jumper
Refer to the illustration below to set jumpers.
Pin closed
Open
1-2
2-3
When two pins of a jumper are encased in a jumper cap, this jumper is closed, i.e.
turned On.
When a jumper cap is removed from two jumper pins, this jumper is open, i.e.
turned Off.
8
3
2
Oblique view
A jumper cap
Schematic illustration
IP417 User's Manual