Advertisement
Audio Indicators for Programmable
Buttons
Some programmable buttons use audio
indicators to indicate the change as they
alternate between two different choices.
Programmable
Positive
Button
Indicator Tone
Currently in Zone
Zone
2
Repeater/
Currently in
Talkaround
Talkaround mode
Start Scan
Scan
operation
Operating in tight
Squelch
squelch
Transmitting at
Power Level
low power
Tones and
All tones and
Alerts
alerts are on
Selecting a Radio Channel,
Subscriber ID, or Group ID
1
Turn the On/Off/Volume Control Knob to
power up your radio.
2
Turn the Channel Selector Knob to select the
required channel, subscriber ID, or group ID.
English
Making a Group or Private Call
Press the programmed One Touch Call button
and proceed to step 2.
OR
Follow the procedure below.
Negative
1
Turn the Channel Selector Knob to select the
Indicator Tone
channel with the active group ID.
Currently in Zone
OR
1
Turn the Channel Selector Knob to select the
Currently in
channel with the active subscriber ID.
Repeater mode
Stop Scan
2
Hold the radio vertically 1 to 2 inches (2.5 to
operation
5.0 cm) from your mouth.
Operating in
3
Press the PTT button to make the call. The
normal squelch
LED lights up solid green.
Transmitting at
high power
4
Wait for the Talk Permit Tone to finish (if
All tones and
enabled). Speak clearly into the microphone.
alerts are off
5
Release the PTT button to listen.
6
If the Channel Free Indication feature is
enabled, you will hear a short alert tone
the moment the target radio releases the
PTT button, indicating the channel is free for
you to respond. Press the PTT button to
respond.
OR
If there is no voice activity for a
predetermined period of time, the call ends.
For a Private Call, you hear a short tone when
the call ends.
Your radio must have the Privacy feature
enabled on the channel to send a privacy-
enabled transmission. Only target radios with
the same Privacy Key as your radio will be
able to unscramble the transmission.
Making an All Call
Your radio must be programmed to allow you to
use this feature. Users on the channel cannot
respond to an All Call.
1
Turn the Channel Selector Knob to select the
channel with the active All Call group ID.
2
Hold the radio vertically 1 to 2 inches (2.5 to
5.0 cm) from your mouth.
3
Press the PTT button to make the call. The
LED lights up solid green.
4
Wait for the Talk Permit Tone to finish (if
enabled). Speak clearly into the microphone.
5
If there is no voice activity for a programmed
period of time, the call ends.
When you receive an All Call, you cannot use
any programmed button functions until the call
ends.
Advertisement
