Advertisement
Quick Start Guide Light Controller IP/DALI
Software-based Commissioning
Open browser
Â
Enter IP address (see Network-based Commissioning)
Â
Enter user name/password
Â
Accept the licence agreement
Â
The Light Controller IP/DALI is delivered with the
N
following user name and password: "admin". This
IMPORTANT
should be changed following commissioning.
Starting the Setup Procedure for the
Light Controller IP/DALI
1. LANGUAGE SELECTION
„
System -> Settings -> select desired language.
2. SETUP
„
Recognition and integration of system components
• Select the Light Controllers and then integrate them into the
system via "Search", followed by confirmation with "Connect".
• Integrate luminaires (DALI control gear) and DALI input (input
devices: DALI push button and sensors) into the system by indi-
vidual lines and allocating names.
• Mains buttons are integrated into the system by allocating
names to the connected wired buttons.
• EnOcean components (wireless push buttons, door/window
contacts) must be pressed to be identified by the Light Control-
ler. System integration follows name allocation.
• Touch4Light
This lets you create your own switches and switch functions for
lighting control purposes as well as to activate or deactivate
certain components. The provided push-button and sliding con-
trols also let you use – a tablet PC or a smartphone to – switch
light on or off, dim lighting, call up lighting scenes and activate
time-controlled light sequences.
• IMPORTANT: Integrating VS Extenders will limit the entire system
to its basic control and adjustment functions. Please observe the
information provided on page 5.
Vossloh-Schwabe Deutschland GmbH · Hohe Steinert 8 · 58509 Lüdenscheid · Germany · Tel. +49 (0) 23 51/10 10 · Fax +49 (0) 23 51/10 12 17 · www.vossloh-schwabe.com
3. CONFIGURATION OF SYSTEM COMPONENTS
„
Creation of Luminaire Groups
Configuration -> Groups
• Allocate group name (e.g. office, kitchen, hallway, etc.)
• Assign luminaires to the groups
It is not possible to integrate luminaires into more than
N
one group. For that reason, it is recommended to
create logical, functional groups. Functions that apply
IMPORTANT
to multiple groups can be set in the "Group Functions"
menu.
– Option 1: Assign all luminaires to one group. All luminaires
of all DALI lines can be assigned to a single group.
– Option 2: Individually assign luminaires to a specific group.
– Time-saving assignment: in addition, it is possible to use a
webcam (e.g. tablet PC) to identify a luminaire and thus as-
sign it to a group.
Definition of Group Functions
Configuration -> Group Functions
• Select the group whose functions you wish to configure. Groups
are listed alphabetically.
• Default setting of the minimum dimming level: 126 = 3%
(recommended for commonly available DALI control gear). This
value can be changed using the slider.
A Member of the Panasonic Group
3
Advertisement
