Operation; Chip Keys; Green User Chip Keys; Yellow Manager Chip Key - Melitta Cafina XT6 Operating Instructions Manual

5

Operation

Initial commissioning is carried out by customer service.
If you want to put the machine back into operation
following a standstill, clean the machine as described
(see chapter 8 on page 28).
5�1

Chip keys

Included with the machine are two green user chip keys
and one yellow manager chip key.
5�1�1

Green user chip keys

The green user chip keys can be used to carry out the
following actions:
• Switching the machine on/off.
• Changing the filling levels.
• Carrying out a full cleaning of the machine.
• Cleaning the touch screen.
5�1�2

Yellow manager chip key

The yellow manager chip key provides the same options
as the user chip key. The following additional actions can
be carried out:
• Making settings on the machine.
• Editing the dispensing products.
• Creating/editing product groups.
• Displaying consumption and product statistics.
5�1�3

Without chip key

Waiter operation
Without a chip key, the following options are available in
waiter operation:
• Dispensing preset products.
• Emitting steam.
• Switching off the machine.
• Changing the filling levels.
• Carrying out a full cleaning of the machine.
• Cleaning the touch screen.
Self-service operation
Without a chip key, you can only dispense preset products
in self-service operation.
26646 • 20160202

Operation

5�1�4

Logging in with a chip key

1. Hold one of the chip keys on the contact surface (1)
on the front of the machine so that the inner and
outer contact surfaces are fully connected to one
another by the chip key.
9 You are logged in and can use the corresponding
functions.
5�2

Switching the machine on and off

5�2�1

Switching on

1. Check that the water supply is on.
2. Open the grounds drawer door (see chapter 5.5 on
page 13).
3. Switch the machine on using the main switch on the
left.
4. Continue as described in chapter 5.2.2 on page 9.
Note
The main switch can be used to switch the
machine off entirely, e.g., during extended
standstills.
5�2�2

Stand-by operation

In daily operation, it is sufficient to switch the machine
on and off via the display only (stand-by operation):
1. Depending on the operating mode, proceed as
follows:
• Self-service operation: Hold one of the chip keys
on the contact area on the front of the device.
• Waiter operation: Touch the display.
The question "Switch on unit?" is shown on the display.
1
Fig. 3: Logging in with a chip key
9
5