CYBEX 625T Installation Instructions Manual
Apple ipod, iphone upgrade kit
Hide thumbs
Also See for 625T:
- Service manual (209 pages) ,
- Owner's manual (88 pages) ,
- Owner's manual (82 pages)
Advertisement
Quick Links
Kit Number KAX-25113
This instruction sheet describes how to install the Apple upgrade kit for Cybex treadmill model 625T.
Tools Required
Phillips screwdriver
•
Utility knife
•
ESD (Electrostatic Discharge) grounding strap
•
Read and understand all instructions thoroughly before installing this kit.
Verify the kit contents shown.
1
4
5
6
7
8
Apple iPod, iPhone Upgrade Kit 625T
2
3
Page 1 of 7
Installation Instructions
Description
1 iPod assembly,
AX-24137
2 Screw, 6-19 x 0.50",
HS-18320
3 Decal, Headphone
jack, DE-22784
4 Cable, Ground,
AW-22357
5 Cable, GFX to MCC,
AW-22537
6 Cable, iPod, 30 pin,
AW-22697
7 Cable, Headphone
jack, AW-22480
8 Cover, iPod access,
PL-24244
www.cybexintl.com
Qty.
1
4
1
1
1
1
1
1
Advertisement
Related Manuals for CYBEX 625T
Summary of Contents for CYBEX 625T
- Page 1 Apple iPod, iPhone Upgrade Kit 625T Installation Instructions Kit Number KAX-25113 This instruction sheet describes how to install the Apple upgrade kit for Cybex treadmill model 625T. Tools Required Phillips screwdriver • Utility knife • ESD (Electrostatic Discharge) grounding strap •...
- Page 2 Disconnect power source Unplug the power cord from the power outlet. WARNING: Shock and electrocution hazard Unplug unit and let sit 10 minutes before cleaning or performing maintenance • Electrical charge can remain in unit after unplugging • Keep water and liquids away from electrical parts •...
- Page 3 2. Unplug the headphone jack cable carefully from the connector J6 on the MCC board (connector on right). Pull connector straight out, cable uses a 90 degree connector. Non A/V models Remove the two screws securing the access cover to the handset using a Phillips screwdriver. Description Access Cover Screws...
- Page 4 3. Lift the handset assembly carefully and unplug the following cables: contact heart rate grips (J7), and handset membrane (J9). Description Handset Membrane (J9) Contact Heart Rate Grips (J7) Install access cover 1. Remove the two screws securing the access cover to the handset using a Phillips screwdriver. Description Handset Screw...
- Page 5 2. Plug the GFX to MCC cable into the iPod board. Install headphone jack cable (non A/V units) 1. Remove the blank decal from the headphone jack cover using a utility knife. 2. Install the headphone jack decal on the headphone jack cover. nstall the nut into the front of the headphone jack cover.
- Page 6 3. Install the eight screws securing the handset assembly to the console using a Phillips screwdriver. Description Handset Assembly Console Screws Install handset cover 1. Plug the headphone jack cable into the connector J6. Description Connector J6 Headphone Jack Cable Headphone Jack Cover Screws Handset...
-
Page 7: Complete Installation
Apple Inc., registered in the U.S. and other countries. 10 Trotter Drive Medway, MA 02053 508-533-4300 • FAX 508-533-5183 • www.cybexintl.com Copyright © 2014, Cybex International, Inc. All rights reserved • LT-25115-4 A • July 2014 Page 7 of 7 www.cybexintl.com...