CYBEX 625T Installation Instructions Manual page 3

2. Unplug the headphone jack cable carefully from the connector J6 on the MCC board
(connector on right). Pull connector straight out, cable uses a 90 degree connector.
Non A/V models
Remove the two screws securing the access cover to the handset using a Phillips screwdriver.
1
Remove handset assembly
1. Remove the eight screws securing the handset to the console using a Phillips screwdriver.
1
Use flashlight to locate cable connectors.
2. Unplug cables by pinching latch and make sure it releases connector. Pull connector out.
DO NOT PULL
CONNECTOR OUT
BY THE WIRES!
3
2
2
3
Latch
Description
1 Access Cover
2
Screws
3 Handset
Description
1
Handset Assembly
2 Console
3 Screws
Page 3 of 7
Pull Straight Out
From Connector
www.cybexintl.com
Qty
1
2
1
Qty
1
1
8