CYBEX 625T Installation Instructions Manual page 5

2. Plug the GFX to MCC cable into the iPod board.
Install headphone jack cable (non A/V units)
1. Remove the blank decal from the headphone jack cover using a utility knife.
2. Install the headphone jack decal on the headphone jack cover.
nstall the nut into the front of the headphone jack cover.
3. I
3
4. Screw the headphone jack cable into the headphone jack cover and tighten by hand.
Install handset assembly
1. Place the handset assembly in position and plug in the following cables: iPod board (J12),
ground wire, handset membrane (J9), and contact heart rate grips (J7).
2
2. Insert the strain relief of the iPod cable into the notch in the access cover.
1
2
1
2
1
3
1
2
3
Description
1 iPod Board (J12) (under cover)
2
Ground wire
3 Handset Membrane (J9)
4 Contact Heart Rate Grips (J7)
4
Description
1
iPod cable strain relief
2 Access cover notch
Page 5 of 7
Description
Headphone Jack Cover
Nut
Headphone Jack Cable
Qty
1
1
1
Qty
1
1
1
1
Qty
1
1
www.cybexintl.com