Before Using For The First Time - Westinghouse WST2011ZE Owner's Manual

BEFORE USING FOR THE FIRST TIME

1. Carefully unpack Hand Mixer.
2. Wash Beaters and Dough Hooks in warm, soapy water. Rinse well
and dry thoroughly.
3. Wipe Mixer with a soft, clean cloth or sponge.
Never immerse Motor Housing in water or any other liquid.
ATTACHING BEATERS/DOUGH HOOKS
Be sure the Mixer is unplugged.
NOTE: One Beater/Dough Hook has a
small, metal Washer-Ring (Collar) around
the top of the Stem. The Beater/Dough
Hook with the Washer-Ring is the one you
insert into the deeper of the two holes in
the Mixer.
1. Push the Beater or Dough Hook with
the Washer-Ring into the deeper hole.
Rotate the Beater until it locks into
position. (See Figure 1.)
2. Push other Beater or Dough Hook
(without Washer-Ring) into other Mixer
hole. Rotate the Beater until it locks
into position. (See Figure 2.)
3. After installing the Beaters or Dough
Hooks, gently pull on each Stem to be
sure they are secured properly.
CAUTION: Always unplug Mixer from outlet before installing
or removing Attachments.
Use either both Beaters or both Dough Hooks. Do not attempt
to use a Dough Hook with a Beater or mismatching Beaters
(one Heavy Duty with one Wire).
This could damage the Mixer.
REMOVING BEATERS
1. Slide Speed Control Lever to the OFF position.
2. Unplug appliance.
3. Push down on the Beater Eject Button to eject Beaters.
Washer-
Ring
Collar
6
Stem
deeper hole
Figure 1
Figure 2