Care And Cleaning - Hamilton Beach 40993C Manual

Care and Cleaning

1
With kettle unplugged, empty any
remaining water and rinse. Allow
kettle to cool. To avoid scale/lime
deposit buildup, empty kettle
after each use.
NOTES:
• To remove discoloration or scale/lime deposit from heating
element: Place 1/2 teaspoon (2.5 ml) cream of tartar (available in the
spice aisle of grocery store) into the kettle. Then fill the kettle 1/2 full
with water. Plug in, turn ON (I), and bring to boil. Turn OFF (O), let
cool, and rinse several times with clean tap water.
• Only use kettle to heat water. If kettle is used to heat other liquids,
such as coffee or tea, the warranty will be voided.
2
Wipe the exterior of kettle with a
damp cloth. Do not use abrasive
scouring pads or powders since
they may scratch the smooth
surface of the kettle.
w WARNING
Electrical Shock Hazard.
Do not immerse kettle, power base, or plug in water or other liquid.
If Kettle Floor Discolors: It is normal for stainless steel heating
elements to discolor. This does not affect the performance of the
kettle. Do not use abrasive scouring pads or cleaners since this may
damage the stainless steel surface.
If Kettle Boils Dry: If your kettle is accidentally switched on without
being filled with water, or is allowed to boil dry, the kettle will shut off
automatically. You should:
• Turn the switch to OFF (O), unplug, and wait about 15 minutes for
the element to cool down.
• Refill the kettle; then use as normal and check that the kettle
functions correctly.
If Kettle Does Not Work: Make these simple checks before calling
the toll-free customer assistance number:
• Have you turned power switch to ON (l) position?
• If the kettle heats but does not boil, it might need descaling.
• Has the kettle been accidentally switched on without being filled
with water or allowed to boil dry? Turn the switch to OFF (O), wait
15 minutes, and try again.
• Is cord firmly plugged into the outlet?
Anti-Scale Mesh Filter: Scale is caused by lime and calcium in
hard water. The mesh filter will prevent these suspended particles
from being poured out of the kettle. The filter should be cleaned
periodically to ensure optimum performance. To clean the filter,
unplug kettle and allow to cool. The mesh filter may be removed
by pulling upwards on the tab, which is visible through the kettle
opening. Rinse filter under running water and brush with a soft
brush. A small, soft-bristle brush works well. To replace the mesh
filter, slide the filter back into the slots. The filter will fit only one way.
7