Before Use; Using The Steam Generator; Re-Filling During Use - Morphy Richards SPEED STEAMPRO Instructions Manual

RN332100 MUK Rev1.qxp_IB 01/08/2018 16:11 Page 6
Remove any protective cover from the soleplate
Unwind and straighten the power cord and steam supply cord.
Locate the steam generator horizontally on the iron rest plate of your ironing board (if large enough) or on a
heat resistant stand at the same height as your ironing board or below it. Always ensure the steam
generator is on a firm surface when ironing.
WARNING: Do not use the product on a surface which could be damaged by heat or steam such as
a worktop or a polished wood surface.
If in doubt, contact Morphy Richards.

Using the Steam Generator

1
Remove the detachable water tank
the water tank handle (11), and fill with water
through the filling aperture
Replace the water tank.
IMPORTANT: Never fill the dirty water chamber
(2).
IN HARD WATER AREAS, WE RECOMMEND A
MIX OF 50% TAP WATER AND 50% DISTILLED,
DEIONISED OR DEMINERALISED WATER.
Never use battery topping up fluid or water
containing any substances like starch, sugar,
fragrant additives or defrosted water from a
refrigerator.
NOTE: Please see point 2 of 'Exclusions' on page 12.

Re-filling during use

If the water level is too low, the unit will not
produce steam. If this happens, refill the
detachable water tank
6
(6)
(12) by pulling
(1) to the max fill line.
(12) with water.
and the base unit (17).
2
Plug the appliance into a mains outlet. Press the
On/Off power button (23), it will beep and the
low steam level indicator (25a) will flash.