Table of Contents
Advertisement
Construction
5.4 Installation options
w
w
w
w
w
w
g
14
Nokia products require power injectors that support a 12.5K Ohm detection resistor and
provide a power output of 60W per port in a 4PPoE implementation.
Nokia recommended midspan devices are listed in the table.
Table 5
Nokia recommended midspan devices
Manufacturer
Micro-semi
Micro-semi
Micro-semi
Phihong
Phihong
For more information and specifications, check the manufacturers' websites.
This chapter describes Flexi Zone Indoor Pico BTS possible installation scenarios, which
are wall, pole and ceiling installations.
NOTICE: Flexi Zone Indoor Pico BTS equipment must be installed by trained and
qualified service personnel in accordance with all local codes and requirements.
NOTICE: Flexi Zone Indoor Pico BTS equipment is intended for installation in restricted
access location or equivalent.
NOTICE: The unit may become hot and should be installed away from any potential
sources of moisture (away from heating or cooling ducts, doors/window). Ensure good
airflow for the unit to allow proper heat dissipation.
NOTICE: The unit should be located away from any RF radiation sources, out of direct
sun exposure, and away from a potential salt spray.
NOTICE: Avoid installing the device near windows to avoid external interference.
NOTICE: When installing the mounting bracket onto a vertical pole or a wall ensure the
arrows point upwards.
For wall, pole and ceiling installation instructions refer to the Flexi Zone Indoor Pico BTS
Quick Start Guide.
The FZ Pico Indoor module can be installed in three possible ways.
Flexi Zone Indoor Pico wall installation
Use the mounting bracket to install the Flexi Zone Indoor Pico BTS onto a wall.
Flexi Zone Indoor Pico BTS Product Description
Model
PD-9606G
PD-9612G
PD-9501GR
POE480U-4UP
POE480U-8UP
DN09210454
Number of ports
6
12
1
4
8
Issue: 01
Hide quick links:
Advertisement
Table of Contents
