Yanmar YSE8 Service Manual page 37

1.2 Mount the bearing metal puller,
1.3 Insert the bearing metal puller into
the bearing metal, draw out bear-
ing meta-l by tightening the puller
nut.
2) Insertion of gear case side main bear-
ing meta.l
2,1 Clean the bearing metal fitting sudace
of the cylinder body.
_ .t.:i2-.2 Reassemble the bearing metal puller
for metal insertion-
2.3 Place a new bearing meta-I upon the
bearing metal insertion tool, with
the chamfer'ed side of the bearing
metal contour facing the cylinder
body.
2.4 Insert both the bearihg metal in-
sertion tool and tbe beadng metal
.
into the bearing metal hole from the
crankca.se side.
Bearing metal insertion tool
t
t
l.s
,
f
- ' ' . .
:.
At,With tbe oil holes
'Hy and of the'b(
o.'r ttr" "yriou#b
agfeerng exac
the bearing m
rnetal
the nut till
2.6 Remove
Drawing-out of flWheel side main bearrtrg
metal
3.1 Remove the oil seal.
3.2 Draw out the bearing metal in the
same way as for dra\,ring-out of
gear case side main bea ng
metal, using the beadng metal
P u L l e "
?
-t
3 )
i