Weslo WLTL39093 User Manual page 6

3. Cut the plastic tie holding the cage nut in the upper end of
Left Handrail (2).
Position the Left Handrail (2) on the left Upright (14). The
lower end of the Left Handrail should be on the outside of
the Extension Leg (41) as shown. Thread a Handrail Bolt
(15) with a Handrail Washer (16) into the left Upright and
the Left Handrail. Do not tighten the Handrail Bolt yet.
Attach the lower end of the Left Handrail (2) to the
Extension Leg (41) with a 3 1/2" Handrail Bolt (59), a
5/16" Washer (32), and a Handrail Nut (82). Do not
tighten the Handrail Bolt yet.
Refer to the inset drawing. Attach the Latch Catch (88)
and the Latch Catch Spacer (74) to the left side of the
Frame (70) with two Screws (55). Do not to overtighten
the Screws or you will damage the Latch Catch.
4. Have a second person hold the Console Base (6) and the
Right Handrail (57) near the right Upright (14) as shown.
Pull any slack wire from the Console Base through the
Bracket. Fold the Wire Harness (26) as shown and insert
the folded Wire Harness into the Right Upright.
Cut the indicated plastic tie off the Handrail (57).
Make sure that the Wire Harness (26) is inside of the
bracket on the Right Handrail (57) and insert the bracket
into the right Upright (14). Make sure that the Wire
Harness is not pinched.
5. Set the Console Base (6) on the Left and Right Handrail
(2, 32). Thread a Handrail Bolt (15) with a Handrail
Washer (16) into the right Upright (14) and the Right
Handrail (32). Do not tighten the Handrail Bolt yet.
Attach the lower end of the Right Handrail (32) to the
Extension Leg (41) with a 3 1/2" Handrail Bolt (59), a 5/16"
Washer (32), and a Handrail Nut (82).
Tighten all parts used in this step and in step 3.
6. Attach the Console Base (6) to the Left and Right
Handrails (2, 57) by threading four Screws (55) into the
Console Base. After all four Screws have been started,
tighten the Screws until they are snug; do not over-
tighten the Screws.
7. Make sure that all parts are tightened before you use
the treadmill. Keep the included allen wrench in a safe
place. The allen wrench is used to adjust the walking belt
(see page 13). To protect the floor or carpet, place a mat
under the treadmill.
3
70
74
88
55
4
6
Bracket
57
5
6
2
41
82
6
57
55
6
15
16
2
14
41
32
59
Plastic Tie
26
14
15
16
32
14
32
59
6
2
82
55