Assembly - Weslo 78e 831.29522.0 User Manual

ASSEMBLY

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed.
Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a nor-
mal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply
wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.
Assembly requires the included allen wrenches
cutters , and needlenose pliers
For help identifying the assembly hardware, see the PART IDENTIFICATION CHART attached in the cen-
ter of this manual. If a part is not in the parts bag, first check to see if it has been pre-assembled. If a part is
missing, call toll-free 1-866-699-3756.
1. Make sure that the power cord is unplugged.
With the help of another person, raise the Uprights (46)
to the vertical position. Insert one of the Base Legs (21)
into the treadmill as shown. (Note: It may be helpful to
tip the Uprights as you insert the Base Leg.) Make sure
that the Thin Base Pad (53) is under the Base Leg
and that the Wheel (68) is positioned as shown.
Insert the other Base Leg (not shown) in the same way.
2. With the help of a second person, carefully lower the
Uprights (46) to the floor. Make sure that the Base
Legs (21) do not fall out of the base of the Uprights.
Attach the Base Legs with the four Base Leg Screws
(62).
Attach the two Base Pads (63) to the base of the
Uprights (46) in the locations shown with the two 3/4"
Tek Screws (3).
With the help of another person, raise the Uprights (46)
to the vertical position.
and your own phillips screwdriver
.
1
2
63
46
6
46
53
21
68
3
62
, wire
63
3
62