Weslo 78e 831.29522.0 User Manual page 8

6. Set the Console (65) in the Console Base (52). Make sure
that no wires are pinched. Insert as much of the Wire
Harness (60) as possible down into the hole in the right
Handrail (59). Securely tighten the plastic tie nearest to
the right Handrail. Pull any excess Wire Harness
between the plastic ties tight and then tighten the other
plastic tie. Cut off the ends of the plastic ties.
Cover the Wire Harness (60) with the Wire Cover (11),
and route the Wire Harness out of the hole in the side of
the Wire Cover. Attach the Wire Cover to the back of the
Console Base (52) with two 3/4" Screws (2). Do not over-
tighten the Screws.
Attach the Console (65) to the Console Base (52) with
five 3/4" Screws (2) in the locations shown. Note: There
should not be a Screw in the hole indicated by the
arrow. Do not overtighten the Screws.
7. Attach the Storage Latch (48) to the left Upright (46)
with two 3/4" Screws (2).
8. Make sure that all parts used in assembly are properly tightened before you use the treadmill. Keep
the included allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see page
13). To protect the floor or carpet, place a mat under the treadmill.
6
Ties
7
8
No
Screw
52
2
60
2
11
2
59
46
48
65
2