7.3
Recommended Soldering Condition
Recommended soldering temperature is as follows:
Soldering Dip :
Preheat
7.4
Recommended Washing Condition
After soldering, the following washing condition is recommended.
For other washing conditions, consult TDK-Lambda Americas Technical Support.
(1) Recommended washing solution
IPA (Isopropyl Alcohol)
(2) Washing method
In order to avoid penetration inside the power module, washing should be done with brush. Then, dry up thoroughly
after washing.
REV 2.8 (March 30, 2020)
Fig. 7-2c PFH500F-48-xxx Derating Curves.
260 ± 5 ºC, within 10 seconds
:
130 ºC
TDK-Lambda
PFH500-SERIES
INSTRUCTION MANUAL
29