Table of Contents
Advertisement
ASSEMBLY
Place all parts of the PURSUIT 895i in a cleared area and remove the packing materials. Do not dispose of
the packing materials until assembly is completed.
Assembly requires the included allen wrench
adjustable wrenches
1. Identify the Front Stabilizer (51), which has Wheels
(25) on the ends.
Hold the Front Stabilizer (51) against the saddle on
the front of the Frame (15). Attach the Front
Stabilizer with two M8 x 90mm Carriage Bolts (9)
and two M8 Nylon Locknuts (21).
2. Make sure that there is a Stabilizer Endcap (48) on
each end of the Rear Stabilizer (52).
Hold the Rear Stabilizer (61) against the saddle on
the rear of the Frame (15). Make sure that the Rear
Stabilizer is turned so the square holes are facing
away from the saddle. Attach the Rear Stabilizer
with two M8 x 90mm Carriage Bolts (9) and two M8
Nylon Locknuts (21).
3. The Console (7) requires two "AA" batteries (not
included). Alkaline batteries are recommended.
Refer to the inset drawing. Open the battery cover
on the underside of the Console as shown. Press
two batteries into the battery compartment. Make
sure that the negative ends of the batteries
(marked "–") are touching the springs in the
battery compartment. Close the battery cover.
Insert the console wire through the Handlebar Post
(14). Connect the console wire to the Reed Switch
Wire (54). Attach the Console (7) to the Handlebar
Post with four M4 x 16mm Screws (4).
Carefully slide the Handlebar Post (14) onto the
Frame (15). Be careful to avoid pinching the
wires inside the Handlebar Post. Attach the
Handlebar Post with three M10 x 25mm Button
Screws (8) and three M10 Split Washers (31).
Attach the Knob Housing (12) to the Handlebar Post
with an M4 x 16mm Screw (4).
.
6
, a phillips screwdriver
1
51
9
25
2
21
15
48
3
7
4
Console
Wire
54
31
8
and two
25
15
21
21
48
52
9
7
Batteries
Battery Cover
12
4
14
8
31
8
15
Advertisement
Table of Contents
