Table of Contents
Advertisement
ELECTRICAL INSTALLATION
A DEDICATED CIRCUIT OF AT LEAST 40 AMPS IS REQUIRED.
WIRING AND CONNECTIONS MUST BE INSTALLED AND
MAINTAINED IN COMPLIANCE WITH
FEDERAL, STATE, AND LOCAL ORDINANCES.
The dispenser is factory configured for either 208 volts or 240 volts.
The voltage configuration is NOT field convertible.
DO NOT connect unit to electric power until water supply is connected
and turned on.
Be sure HEATER SWITCH is
power.
NOTICE:
(O) before connecting unit to electric
OFF
7
INSTALLATION (continued)
SHOCK HAZARD
Removal of any exterior panel
will result in exposed electrical
circuits. Electrical connection
must be performed by a
qualified technician only.
Use care whenever working
around exposed electrical
circuits.
IMPORTANT:
Contact a licensed electrician
co connect electric power to
the dispenser.
IMPORTANT:
Damage due to being
connected to the wrong
voltage or phase is NOT
covered by warranty.
IMPORTANT:
Supply voltage must
correspond to the nameplate
voltage of the unit. Connection
to the wrong voltage can result
in equipment damage or
reduced performance.
Such damage is not covered
by warranty.
CAUTION:
Advertisement
Table of Contents
