Table of Contents
Advertisement
CLEANING INSTRUCTIONS (continued
CAUTION
Burn Hazard
Water in Water-Max II™ is
EXTREMELY HOT! Wear
appropriate heat protective
clothing when draining water
from unit.
IMPORTANT:
Never drain internal tank with
HEATER SWITCH
.
ON
Tank heating element will be
damaged if allowed to
operate without water.
For description of features
refer to page 2.
CONTINUED FROM PAGE 11
After 30 minutes, flush solution from main tank (HEATER SWITCH
Insert drain hose into a suitable container. Open drain hose clamp and
drain valve. Allow all solution to drain.
Close drain valve. Reconnect main water supply and allow main tank to
fill (approximately 4 minutes).
After tank is filled, disconnect main water supply and drain tank again.
Flush tank in this manner at least two (2) times.
After flushing tank:
Be sure drain valve and drain hose clamp are closed. Stow drain hose
and reconnect main water supply. After tank is filled (approximately 4
minutes), press HEATER SWITCH to
tank will begin filling. When water reaches proper temperature, satellite
will begin filling.
Procedure is complete
12
( I ). After a short delay, main
ON
):
OFF
Advertisement
Table of Contents
