Raymarine AXIOM+ Series Installation Instructions Manual page 32

Note: The illustration depicts an Axiom™ 7 being mounted on a plastic trunnion bracket. The
trunnion bracket supplied with the Axiom™ 9 and Axiom™ 12 are made from metal and so look
different than the trunnion shown. A metal trunnion bracket is also available for the Axiom™ 7 as an
accessory; Part number: R70524.
1. Using the Bracket as a template, Mark and drill 4 x pilot holes on the mounting surface.
2. Use self tapping screws to secure the trunnion bracket to the mounting surface.
If the mounting surface is too thin for the screws provided, use stainless steel machine screws,
washers and locking nuts, alternatively reinforce the rear of the mounting surface.
3. Using the bracket knobs, secure the MFD to the Bracket, ensuring the ratchet teeth are correctly
engaged.
The knobs should be tightened by hand, sufficiently to prevent the MFD from moving whilst your
vessel is underway.
4. Route and connect necessary cables.
32