Fast Forward/Fast Reverse
●
Crown
Normal timekeeping
Second click
First click
After pulling out the crown to the first or second
click, rotating it quickly in succession in either
direction will start a fast forward or fast reverse
operation. While a fast forward operation is in
progress, quickly rotating the crown in
succession again will increase the speed even
further.
Stopping Fast Forward/Fast Reverse
●
Rotate the crown in the direction opposite that
of the ongoing operation or press any button.
Note
If you do not perform any operation for
●
about two minutes after pulling out the
crown, crown operations will
automatically become disabled. If that
happens, push the crown back in and
then pull it out again.
Hand and Day Indicator
Movement
Mode hand
Day indicator
Mode Hand and Day Indicator
●
Movement
Changing the day setting of the watch will also
cause the mode hand to move.
Day
●
It can take anywhere from about 10 to 40
●
seconds for the day indicator to change
after timekeeping reaches midnight. The
mode hand moves as the day indicator
changes.
The day may not be indicated correctly
●
while the watch's crown is pulled out.
Watch Operation Guide 5636
Shifting the Hands
Hand shift moves the hands out of the way for
easy viewing of display info.
1.
Press (A).
This will shift the hands to allow easier
●
reading of face information.
2.
To return the hands to their normal
timekeeping positions, press (A) or (D), or
press (C) to change to another mode.
Note
If you leave the watch with its hands
●
shifted and do not perform any
operation for about ten seconds, the
hands will resume normal timekeeping
automatically.
Solar Charging
This watch runs on power supplied from a
rechargeable (secondary) battery that is
charged by a solar panel. The solar panel is
integrated into the face of the watch, and
power is generated whenever the face is
exposed to light.
Charging the Watch
●
When you are not wearing the watch, put it in
a location where it is exposed to bright light.
While you are wearing the watch, make sure
that its face (solar panel) is not blocked from
light by the sleeve of your clothing. Power
generation efficiency is reduced even when
the face of the watch is blocked only partially.
YES
NO
Important!
Depending on light intensity and local
●
conditions, the watch may become hot
to the touch when exposed to light for
charging. Take care to avoid burn
injury after charging. Also, avoid
charging the watch under high-
temperature conditions like the ones
described below.
On the dashboard of a vehicle
ー
parked in the sun
Near an incandescent light bulb or
ー
other source of heat
Under direct sunlight or in other hot
ー
areas for long periods
Remaining Charge and Dead Battery
●
You can determine if the charge level is low by
checking the hand movement. Functions
become disabled as battery power goes low.
Important!
Should the battery go low or go dead,
●
expose the face (solar panel) to light as
soon as possible.
Note
Exposing the watch face to light after
●
the battery goes dead will cause the
second hand to revolve
counterclockwise until it stops at
second 57. This indicates charging
has started.
Low Battery Power
The second hand jumps at two-second
intervals.
Second hand
4