How To Dismantle And Reassemble The Lid; How To Remove The Metal Plate; How To Take The Valve Cover Off; Accessing The Decompression Ball - Moulinex Cookeo EPC03 Series Manual

before
use
HOW TO
DISMANTLE
AND REASSEMBLE
THE LID
3

ACCESSING THE DECOMPRESSION BALL:

When the lid is completely cool, turn the ball cover, anti-clockwise, so
as to bring the marker into position
I
the ball, and gently clean it, along with its cover, with water and some
washing-up liquid. Dry the ball using a soft cloth, then put it back in
position. Put the ball cover back in place, and the marker
. Lock it by turning the ball cover so that the marker is opposite
the pictogram "closed" .
Note: The metal decompression ball may still be hot even when
the lid has cooled.
1
HOW TO REMOVE THE METAL
PLATE:
Grip the lid sub-assembly holding it by the
seal, and unscrew the central nut in an
anticlockwise direction. Remove the nut then
the lid.
4
PUTTING THE METAL PLATE BACK
IN PLACE:
Grip the metal plate by the seal as shown in the
.Lift the cover up. remove
picture. Line up the metal plate with the central
screw spindle and press it flat against
the underside of the lid. Put the nut back on with
in position
I
the flat side facing the metal plate and turn it
clockwise, tightening it as far as it will go.
Note: The notches on the rotating inner part
of the lid must be correctly aligned with the
notches on the rim of the bowl otherwise the lid
will not lock when closed.
2

HOW TO TAKE THE VALVE COVER OFF:

Clasp the valve cover by its middle part (as shown) ; then
turn it slightly to unclip it. Clean the valve cover, paying special
attention to the inside (check that there is no left over food).
5
PUTTING THE VALVE COVER BACK:
Take the valve cover as shown in the picture
(gripping the middle). Line up the interior
circular shape with the three hooks and then
push so that the valve cover clips on (you
should hear a "clip" sound). The valve cover
must be right up against the inside of the lid.
en
210